Commercial Heating Repair in South Jersey: Rooftop Units, Furnaces, Boilers and Unit Heaters

The short answer

When a store, restaurant or office in South Jersey loses heat, the cause is usually in the ignition and flame safety circuit, the blower or inducer, the gas valve, or the controls. Rooftop units, furnaces, boilers and unit heaters all share those weak points. Gesser Services repairs commercial heating equipment from Atlantic City to every town within 50 miles, and urgent visits are available based on technician availability.

5.0 on GoogleRead our reviews
  • Atlantic City + 50 miles across South Jersey
  • A written quote before any repair
  • Nothing is repaired without your approval
Gas furnace with PVC venting, installed in a closet

What to check first

  • Thermostat and schedule

    Commercial thermostats run schedules. Check the mode, the setpoint and any override.

  • Power and switches

    Check the breaker and the service switch at the unit. Rooftop units have one on the roof.

  • Filters

    Clogged filters trip high-limits and shut the burner off. Replace them if they are packed.

  • Codes and lights

    Write down the blinking code on the control board if you can see it safely.

Is this your problem?

Pick what you see to read what it usually means.

Is this your problem?

The igniter, a flame sensor, a pressure switch or the gas valve; on a heat pump, the defrost or reversing valve.

Get help with thisSee AC and heating repair

A dirty flame sensor, a clogged filter tripping the high-limit or a thermostat problem.

Get help with thisSee AC and heating repair

Airflow, ductwork, dampers or a system that struggles to keep up.

Get help with thisSee AC and heating repair

A motor, the inducer, a pump or a valve.

Get help with thisSee AC and heating repair

Equipment we repair

  • Rooftop units (RTUs) with gas heat or heat pumps, on stores, restaurants and offices
  • Gas furnaces in back rooms, ceilings and closets
  • Boilers for hot water and baseboard heat
  • Unit heaters in garages, warehouses and kitchens
  • Makeup air units that temper the air a kitchen hood pulls out

Why commercial heat stops

The burner will not light or stay lit

A cracked or weak igniter, a dirty flame sensor, a failed inducer or pressure switch, or a gas valve. After a few failed tries, the control locks out.

Heat comes and goes

A high-limit trips because airflow is low: dirty filters, a slipping belt, a weak blower motor or closed dampers. On heat pumps, a defrost problem.

Some areas stay cold

Airflow and duct problems, a zone damper stuck, or a system that is too small for the space after a remodel.

It runs but the air is cool

Only part of a multi-stage burner firing, a heat exchanger that is not getting gas, or an economizer letting in too much outside air.

Burners of an open gas furnace
Burners of an open gas furnace

How an urgent heating visit works

Call (609) 826-1174 and describe the equipment and what it is doing. Emergency service is available based on technician availability; see emergency service. On site, the technician tests the ignition sequence, safeties, gas supply, blower and controls, explains the cause and gives you a written quote. Nothing is repaired without your approval.

For planned work, book a visit online or see AC and heating repair.

Fewer heating calls in winter

  • A fall check: burners cleaned, flame sensor and igniter tested, heat exchanger inspected, belts and filters replaced.
  • Rooftop units: clear debris around them and make sure access to the roof is easy for a technician.
  • Kitchens: keep makeup air and hood interlocks working, or the heat and the cooking line both stop.
  • A maintenance plan keeps the check on the calendar for every unit.

Repair or replace?

What to look atRepair usually makes sense whenReplacement is worth pricing when
The problemA capacitor, a contactor, a fan motor, an igniter or a sensor.A failed compressor or heat exchanger on an older system.
The systemIt heated and cooled well until this problem.Rising bills, rooms that never reach temperature and repeated repairs.
The refrigerantIt uses a refrigerant that is still made today.It uses R-22, which is no longer produced, so a recharge is expensive.

A technician measures the system and gives you a written quote, so you can compare repairing with replacing before you decide.

Brands we work on

Gesser Services is an independent service company and is not affiliated with these manufacturers. Brand names and logos belong to their owners.

Questions people ask

Do you offer emergency heat repair in South Jersey?

Yes. Emergency service is available based on technician availability. Call (609) 826-1174 and describe what the system is doing.

What commercial heating systems do you repair?

Rooftop units, gas furnaces, boilers, unit heaters and makeup air units in stores, restaurants, offices and warehouses.

Why does my rooftop unit keep shutting off on heat?

Most often a high-limit tripping from low airflow, a flame sensor losing the flame, or an inducer or pressure switch problem.

Will I get a price before the repair?

Yes. The technician finds the cause first and gives you a written quote. Nothing is repaired without your approval.

Where we work

Atlantic City and every town within 50 miles, homes and businesses.

  • Atlantic City
  • Ventnor City
  • Brigantine
  • Margate City
  • Pleasantville
  • Absecon
  • Longport
  • Northfield
  • Linwood
  • Smithville
  • Egg Harbor Township
  • Somers Point
  • Ocean City
  • Pomona
  • Galloway
  • Port Republic
  • Mystic Island
  • Marmora
  • New Gretna
  • Beach Haven
  • Egg Harbor City
  • Tuckerton
  • Estell Manor
  • Mays Landing

And 95 more towns. See the service area

Need help with AC and heating repair?

Central AC, heat pumps, furnaces, boilers and mini-splits. Tell us what it is doing and the team takes it from there.

Similar Posts